Speed Blender – White
Blenders are used to process food so it is very important to keep them clean at all times. This is important, not only to the taste of the food prepared in the blender, but also for its quality and safety. The blender must not only look clean, but it must be free from harmful germs or bacteria.
Some blender jars can be washed using a dishwasher. However, it is best to check before doing so, because using a dishwasher on blender jars that should be washed in a different manner may cause their blades to dull.
For blenders that have to be washed by hand, the following steps should be followed.
Separate the parts of the blender. Obviously, the electrical components should not come into contact with water. All the others should be cleaned thoroughly and properly.
The jar is the part of the blender that you most have to pay attention to when cleaning. It is where most of the food residue is located, so you have to make sure that you remove all of it. There are a lot of hard-to-reach places in a blender jar, so it may be hard to determine if all the remnants have been washed away. A good way to ensure that nothing is left behind is to fill the jar with lukewarm water, then add dishwashing soap. Turn the blender on high and let it run for a few seconds. This allows the soap and the water to get under and in between the blades. You can also wash the jar with soap and a sponge for more thorough cleaning. If there are bits and pieces of food that are difficult to remove, you can soak the jar in a baking soda and water solution. This will soften the food particles and make them much easier to remove. Wash the jar with soap and water after soaking. Make sure that you rinse the jar well and that absolutely no soap is left behind.
You also have to clean the other detachable parts to make sure that no food and dust is stuck to them. Like the jar, you can wash them with water and dishwashing liquid.
For the part of the blender with the motor, or the base, you can just use a damp cloth to wipe it down. You may also opt to spray it with a glass cleaner, and then use a soft piece of cloth to buff it. All purpose cleaners may be used as well. If this is not available, the baking soda and water solution is a good alternative. Just remember never to submerge the base in liquid. Wiping it down is enough.
You have to make sure to dry these components well before reassembling the blender and storing it.
